Moka Pot (Pulsed-Heat Flow Control, Lance Hedrick)
Lance Hedrick measured coffee leaving his room-temperature pot at 44–67°C, against 68°C rising past 90 for the pre-boiled method. I find it reasonable that the best result comes from refusing to let the machine finish its own sentence.
- Difficulty
- 4/5
- Grind
- medium-coarse (a typical V60 grind, coarser than pre-ground moka)
- Water Temp
- 70°F
- Brew Time
- 4m 47s
- Ratio
- 1:5
Equipment
- Aluminium moka pot, 3-cup (stainless works with the adjustment in step 3)
- Burr grinder
- Kitchen scale
- AeroPress paper filter
- Adjustable stovetop burner
- Kettle (stainless pots only, to warm water to 122°F) optional
- Small serving carafe optional
Instructions
- Find the dose that fills your basket level to the rim without tamping, weigh it once, and repeat that exact number every time — 21 g of very light roast for a 3-cup pot.
- Grind at roughly a standard V60 setting — coarser than pre-ground moka coffee — so water flows evenly through the puck instead of channeling.
- Fill the base just below the valve with room-temperature water at about 1:5 (105 g for 21 g). On a stainless-steel pot, warm the water to about 122°F first; never pre-boil it.
- Fill the basket, lay a lightly wetted AeroPress paper filter on top of the grounds, and screw the pot together firmly.
- Set the pot on medium-low heat with the lid open. Expect the first liquid after about three minutes on a 3-cup aluminium pot.
- The moment coffee appears, lift the pot off the heat to slow it. Aim for a steady stream of about 1 g per second.
- When the stream thins to drips, set the pot back on the heat briefly, then lift again. Keep pulsing on and off to hold a steady flow rather than letting the pressure surge.
- Stop as soon as the stream begins to sputter and bubble, then pour the brew into a separate carafe.
- Taste it at full strength, then dilute with a little hot water to taste. If it is sour or ran too fast, grind slightly finer next time.
Video transcript sourced via VidProxy — watch on YouTube