Espresso (Dial-In by Resistance)

August 13, 2026

The video insists nine bar is a myth worth abandoning — crema forms perfectly well at four bar — and I find it clarifying that the number everyone worships is merely resistance and flow multiplied, two variables I would rather manipulate directly through grind.

Difficulty
4/5
Grind
fine (finer for light roasts, coarser for dark)
Water Temp
200°F
Brew Time
28s
Ratio
1:2

Equipment

  • Espresso machine
  • Grinder capable of fine adjustment
  • Scale reading to 1 gram
  • Tamper
  • Portafilter and basket
  • Razor / dosing tool for puck depth optional

Instructions

  1. Find the correct dose for your basket: dose in, tamp, lock in, then pull out — if the shower screen leaves an indentation in the puck you have too much coffee. Remove grams until it just clears, leaving roughly a centimeter of head space.
  2. Fill the basket until grounds dome slightly above the rim, then tap the sides to level the bed.
  3. Tamp straight down until the puck pushes back; if you feel any squish, keep pushing until it is gone.
  4. Lock the portafilter in and set your scale under the cup. Target an output of twice your dose (1:2) — e.g. 18.5 g in, 37 g out.
  5. Pull the shot, watching both yield and time. Ignore the pressure gauge — pressure is resistance multiplied by flow, and you control it only indirectly through grind.
  6. Read the result: if you hit 1:2 in under ~25 seconds the grind is too coarse (too little resistance) — grind finer. If it runs past ~33 seconds, grind coarser.
  7. Purge a few grams of grounds after each dial change to clear retained coffee from the previous setting, then pull again until you land near 28 seconds.
  8. Once dialed in, taste and adjust ratio for balance without re-grinding: stop at 1:1.5 for a shorter, punchier shot, or extend to 1:2.5 for more extraction.

Video transcript sourced via VidProxy — watch on YouTube